The V8 Owners Forum -

Mine came as part of the complete kit, but can`t see why they won`t sell them individually.

Like ChrisJC, I can`t see my timing marks for similar reasons, so I take rocker cover off left hand side, set piston no 1 to TDC on compression stroke by watching where the rocker arms go and position rotor arm just before firing on number 1 lead, worked ok, then adjust it till it sounds about right...

Yep, I got one of them on my Series 3 to relocate the filter/pump assy away from the front diff as stated.

You can get one from here

Isn`t that the earlier type ?? Thought the later ones has a dog on top instead of the slot as in pic ????

I have a pair of early Range Rover manifolds with the single bore outlet but the rh one is the type with the detox pipe on it.

Also have a pair of the later twin bore manifolds. If either are any good let me know.

Marki, many thanks, where electrics are concerned they have to be explained in very simple terms.

Chris

That`s what I want to do but a bit unsure wire to wire the switch in ?

I have a 16" kenlowe pusher fan wired to a relay and then a thermostat. Off the thermostat is a copper wire with the torpedo shaped sensor that fits into the top rad hose (the one with the red sealing band). No matter how I try I cannot get this to seal correctly. How can I re-connect the fan t...

was going to take inspection cover off yesterday but it p***ed down all day. can get reverse with engine off but it`s a hard fight, thought it might be something to do with the release bearing not travelling far enough forward.

oh well, engine out again !!

thank
Chris

did bleed clutch before I put engine in but not sure if I got all the air out, will do it again to be sure

Finally got engine running but can`t select any gears, have heard of this happening before so if anyone can give me a bit of advice it would be greatful.

Series 3 Land Rover with 3.5 V8 Rangie engine on standard series box.

Thanks
Chris

just a quick thank you to you all, it was the starter after all !

chris

exactly the one`s. I found them in the parts manual but didn`t show where they were going.

as ever, many thanks
Chris

Simple question here, I have twin Strombergs and where the carbs fit to the air filter elbows there is a small pipe about 10mm diameter and bent at 90 degrees, one end fits to a tube in the casting the other end has long flexible tube coming out of it. What are these tubes for and where does the oth...

Thanks for the info. Know what you mean about the sand, still can`t get it all off my drive and I havn`t been there for six months.

Chris