Vitesse / Discovery efi Plenum clearance ?

Camo · Post by **Camo** » Sun Jun 03, 2012 8:24 am

Hi Folks,

I have been looking at various carb options for my V8 Moss regarding the bonnet and how much of a bulge / scoop I will need.
I obviously want the lowest I can go but will be buying secondhand at this stage in my life

I have ruled out Twin SU type, I have a Holley 390 on there currently but feel the EFi set up from the Rover Vitesse / Discovery 3.9 would be lower.
Anyone have the height from the top of the rover cover to the plenum top measurement to hand ?

Thanks,

Stu

DaveEFI · Post by **DaveEFI** » Fri Jun 08, 2012 9:08 am

The injection setup is slightly higher than either the SUs or Solex fitted to the SD1.

SimpleSimon · Post by **SimpleSimon** » Fri Jun 08, 2012 9:47 am

If its a Lucas Hotwire system your using then 16cm approx from top of rocker cover to highest point of plenum top

Camo · Post by **Camo** » Sat Jun 09, 2012 5:33 pm

Thanks guys, looks like its the Holley then...

Cheers,

Stu