Clutch + Flywheel advice for LT77 to 4.6 Gems

mcc1979ian · Post by **mcc1979ian** » Tue Jul 10, 2012 8:52 am

ok so iv finally got the 4.6 gems engine in the garage and the LT77 is ment to be coming today, now the question is which clutch and flywheel should i be running

the 4.6 was attached to an automatic so im assuming that im going to have to change the flywheel for a manual one

clutch, well i honestly i havent a clue which to fit

all help much appreciated

p.s if you could post a link to the parts that would be amazing

thanks as always

ChrisJC · Post by **ChrisJC** » Tue Jul 10, 2012 8:55 am

Check if there's spigot bush in the end of the crankshaft, you need one if not.

Chris.

mcc1979ian · Post by **mcc1979ian** » Tue Jul 10, 2012 10:28 am

need a spigot bush or flywheel

ChrisJC · Post by **ChrisJC** » Tue Jul 10, 2012 8:43 pm

Your easiest option is to get flywheel / clutch etc from an SD1 (presuming that's what the LT77 came from).

If the LT77 came from a Range Rover, then get the flywheel / clutch assembly from one of those.

The engines are all the same as far as crankshaft / gearbox mating flange goes. Just the auto ones didn't get a spigot bush in the end of the crankshaft.

Chris.