rover 4.6 to t5 gearbox

v8 pete · Post by **v8 pete** » Thu Jul 08, 2010 7:32 pm

what clutch plate do i need
mine is slipping need to order a new one
dont have the part number.

hope to order before stripping out engine

SuperV8 · Post by **SuperV8** » Tue Jul 13, 2010 12:13 pm

What T5 do you have?

The TVR sourced Tremac T5 has different spline size to the Cosworth BW T5.

Tom.

richardpope50 · Post by **richardpope50** » Tue Jul 13, 2010 4:52 pm

I had the same problem when I swapped from a TVR V8 to an SD1 V8 (temporary reason). I had to use the TVR clutch which is an AP clutch. Therefore you'll need an AP clutch for your 4.6. I would guess you will also need the whole assembly too and may be a bit pricey from TVR sources and as I want to change my plates I was going to try a motor factors but have not done so yet.

There were several numbers on my AP clutch plate but nothing seemed obvious as a part number but it's in my car at the mo so I cannot really read them off at the moment, sorry.

seight · Post by **seight** » Wed Jul 14, 2010 1:51 pm

For what it's worth I'm using a CP2394-14 with CP2346-4 from AP which is a 9.5" setup on SD1 (I think) flywheel. Probably overkill in a light car like my Westfield. I think I could probably get away with a 'brown spring' version, my is the 'green spring'. But those part numbers are for the Cosworth T5 box spline, you may need a different plate.

Mike

richardpope50 · Post by **richardpope50** » Fri Jul 16, 2010 5:58 pm

TVRpower.co.uk have clutch options.

DEVONMAN · Post by **DEVONMAN** » Fri Jul 16, 2010 6:49 pm

v8 pete wrote:what clutch plate do i need
mine is slipping need to order a new one
dont have the part number.

hope to order before stripping out engine

You will need to establish which flywheel you are using.
Range Rover or SD1 or TVR etc etc etc

Regards Denis

v8 pete · Post by **v8 pete** » Wed Jul 28, 2010 4:40 pm

flywheel not sure rover i believe [been lightened]
clutch plate is bogr warner 25'4 hole 23 spline 240mm outer dia

must be able to take 270bhp and 260 torque

davehoos · Post by **davehoos** » Thu Jul 29, 2010 12:04 pm

http://www.dellowconversions.com.au/ima ... motive.pdf
page 11/35 , 12/35

v8 pete · Post by **v8 pete** » Sat Jul 31, 2010 2:11 pm

ordered a ford transit one
and see how that goes

v8 pete · Post by **v8 pete** » Tue Aug 03, 2010 7:19 pm

fitted and seems to work ok

The V8 Owners Forum -

rover 4.6 to t5 gearbox

rover 4.6 to t5 gearbox

Re: rover 4.6 to t5 gearbox