what is the best and cheapest way to do this.
thanks in advance
Andy
lucas 35d8 (lumenition v pertronix)
Moderator: phpBB2 - Administrators
lucas 35d8 (lumenition v pertronix)
Hi folks I want to change from points to electronic i have lucas 35d8 dizzy
what is the best and cheapest way to do this.
thanks in advance
Andy
what is the best and cheapest way to do this.
thanks in advance
Andy
Last edited by andylamb on Mon Jan 28, 2008 11:22 pm, edited 2 times in total.
The 35d8 belongs the early front cover so using a newer electronic distributor will need the newer front cover. A luminition kit is probably the easiest way to convert this setup to electronic. It isn't what I would call cheap though at around £140. If you were to change the front cover and dizzy it could cost less and you would get a better oil pump in the bargain but it is more work.ChrisJC wrote:Grab a matching coil / distributor from a Range Rover, preferably amp-on-distributor-body type. Then the coil +ve just needs an unballasted 12V supply, and the coil -ve will drive the rev counter.
Chris.
Yes, the quickest and easiest is to buy and install a Lumenition kit.
Remove the points and capacitor, fit an optical eye and chopper, and mount the power module down low, away from heat, and if possible in an air stream.
Lumenition makes kits specific to different Lucas distributors, although it is my understanding that the power module in most cases is the same.
Ron.
Remove the points and capacitor, fit an optical eye and chopper, and mount the power module down low, away from heat, and if possible in an air stream.
Lumenition makes kits specific to different Lucas distributors, although it is my understanding that the power module in most cases is the same.
Ron.
4.6 Rover 3500 P6B
lumeniton v pertronix
what is the differance between lumenition and pertronix set up
the retrorockets site lists a few 35d8 lucas dizzys
1/35d8 w/vacum advance 12v neg
2/ 35d8 w/vacum retard 12v neg
the problem is i havent got a clue the numbers on my dizzy are
35d8 41487 54420642 if someone can help
ta Andy
the retrorockets site lists a few 35d8 lucas dizzys
1/35d8 w/vacum advance 12v neg
2/ 35d8 w/vacum retard 12v neg
the problem is i havent got a clue the numbers on my dizzy are
35d8 41487 54420642 if someone can help
ta Andy
Hello Andy,
Was your Lucas 35d8 distributor out of a Rover P6B?
From my understanding, there were a number of subtle variations to the 35d8 distributors fitted to the P6Bs over the years of production, covering the rate and total amount of mechanical advance, and the points when the vacuum advance would start and finish, plus the total advance that it provided.
In any case, the Lumenition system is the same for all of them.
The power module is PMA50, the optical eye kit is FK114, and the chopper is a 299 usually.
Using a Lumenition kit does not change the rate of mechanical or vacuum advance.
The number 41487 is the type of 35d8 distributor, with corresponding rates of mechanical and vacuum advance. The other may well be a Lucas casting number or similar.
The important two numbers are...the model 35d8, and the type 41487.
Is the vacuum advance still working?
Hope this helps,
Ron.
Was your Lucas 35d8 distributor out of a Rover P6B?
From my understanding, there were a number of subtle variations to the 35d8 distributors fitted to the P6Bs over the years of production, covering the rate and total amount of mechanical advance, and the points when the vacuum advance would start and finish, plus the total advance that it provided.
In any case, the Lumenition system is the same for all of them.
The power module is PMA50, the optical eye kit is FK114, and the chopper is a 299 usually.
Using a Lumenition kit does not change the rate of mechanical or vacuum advance.
The number 41487 is the type of 35d8 distributor, with corresponding rates of mechanical and vacuum advance. The other may well be a Lucas casting number or similar.
The important two numbers are...the model 35d8, and the type 41487.
Is the vacuum advance still working?
Hope this helps,
Ron.
4.6 Rover 3500 P6B
