Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.
How did you get the screw in bung thing out ? I bent allen keys trying to get mine out, even heated the surrounding ally up a bit . Just wanted to clean the galleries out of an engine that had chewed up all the bearing shells .
I wish I was young again , Id be heaps smarter than the first time
How did you get the screw in bung thing out ? I bent allen keys trying to get mine out, even heated the surrounding ally up a bit . Just wanted to clean the galleries out of an engine that had chewed up all the bearing shells .
It was a lot easier with this being a cast iron block. I just put a lot of heat on both of them.