SU carburettor throttle linkage

4.6_crossbolt · Post by **4.6_crossbolt** » Sun Feb 16, 2014 6:25 pm

Does anyone know of a manufacturer or supplier of the rod linkages with sockets at either end that fit the ball connectors on HIF6's?

Burlen Fuel systems do not appear to do the short ones needed for the linkages on a Boxer quad SU set-up.

ChrisJC · Post by **ChrisJC** » Mon Feb 17, 2014 5:54 pm

Could you get a long one cut it down and run a die down the end?

Chris.

4.6_crossbolt · Post by **4.6_crossbolt** » Tue Feb 18, 2014 5:48 pm

Well, I guess that would be one way, but they're quite expensive and I'd rather not start chopping them up. Maybe I'll phone Burlens and ask if they do shorter ones. I just thought that there might be another supplier.

4.6_crossbolt · Post by **4.6_crossbolt** » Tue Feb 18, 2014 7:36 pm

After searching some more on eBay I found an outfit called FastRoadCar that sell mostly Weber stuff, but also universal-fit ball-end linkage rods with threaded rod that can just be cut to size. Sorted.