Chevy 350 inlet manifold....

Jono FD3 · Post by **Jono FD3** » Sat Oct 12, 2013 5:50 pm

Hi guys, I've got an early cast block 4 bolt main engine which has forged rods and pistons etc, but the intake manifold isn't there...... would a Pro Comp intake manifold be up to the job (apparently a copy of the Edelbrock performer) or would it choke the engine a touch?? also would I be able to run turbos on a blow through setup with it or is that really pushing the limits of the manifold??

Cheers
Jono

bigaldart · Post by **bigaldart** » Sat Oct 12, 2013 7:11 pm

For a single 4 barrel it is hard to beat a Victor Jr, best bang for buck out there and will be great for a blow through set up. Check what the fast guys run.

Alan