Nylon spacers

gelmonkey · Post by **gelmonkey** » Thu Nov 22, 2012 1:23 pm

Hi All
I need to get some nylon spacers made for a contract that has come my way and wondered if anyone out there in forum land could make some for me.
They need to be 50mm diameter with a 10mm hole in the middle and 15/19mm high.
I do not have the nylon so this would need to be scourced
I will need 100's of the little buggers over a period of time.
If anyone is interested then please call me on either 01752 706930 or 07773 781997 up to 11pm any night.

cheers
Paul

kiwicar · Post by **kiwicar** » Thu Nov 22, 2012 5:15 pm

Hi Paul
Would this not be a job for an injection molding company, with quantities in the hundreds a small cheep injection molder would seem the answer? If it was a smaller quantity I would just chop them out of nylon bar on a lathe. . .
Sorry can't do either but you may find an injection moulders already set up to do the job, then there would be much less of a cost for the dies . . .
Best regards
Mike

gelmonkey · Post by **gelmonkey** » Thu Nov 22, 2012 5:34 pm

Hi Mike
I understand what you are saying and you are right but I really dont have the time to spend chasing folks on the phone.
Work is immense presently and looks to be going that way for some time which is very comforting.
I would just like to give someone on here the chance to make some dosh for themselves which is why I asked.
I have a mate who can make them for me at his works but they are not particularly cheap even though I will need loads.

Cheers
P

stevieturbo · Post by **stevieturbo** » Thu Nov 22, 2012 7:31 pm

Try Ralph85 off the site

www.componentengineering.co.uk

gelmonkey · Post by **gelmonkey** » Thu Nov 22, 2012 9:12 pm

stevieturbo wrote:Try Ralph85 off the site

www.componentengineering.co.uk

Thanks Steve
Ged has contacted me and I will see what he can come up with first and then I will give Ralph a shout as well.

Thanks again

P