this was discussed before, can anyone say fro sure weather these...
http://www.ebay.co.uk/itm/150933251018? ... 1423.l2649
will fit a 4.6 with crank driven oil pump, no dizzy drive (later serp engine).
have a kent cam which is the same as the original with no extra nose.
if its totally unknown i will just have to buy one and try it!
Ralph
4.6 cam chain
Moderator: phpBB2 - Administrators
The large cam wheel in that set will not bolt onto a 4.6 type cam as the cam does not have a keyway facillity.
The 4.6 gear normally located with a lug and a bolt through a smaller hole in the middle.
Cheers Denis
The 4.6 gear normally located with a lug and a bolt through a smaller hole in the middle.
Cheers Denis
1950 A40 Devon Hotrod with 5.0 twin turbo RV8.
EDIS8 wasted spark, Holley Injection.
Been as far as the Moon and back in 57 years of driving. Same Car, 5 engine upgrades !!!
EDIS8 wasted spark, Holley Injection.
Been as far as the Moon and back in 57 years of driving. Same Car, 5 engine upgrades !!!
your right, and i have just found an old type cam/chain ring and compared, totally different but i think it would be possible to machine in to the cam and fit a nose bit which could stick out, woodruff key would line up with it and the slot in the new cam.
weather its going to be worth doing i dont know.
Ralph
weather its going to be worth doing i dont know.
Ralph
