4.6 Crank

need4speed · Post by **need4speed** » Thu Sep 30, 2010 10:00 pm

Offered up my 3.9 flywheel to my engine to discover that the 4.6 crank has a locating dowel in it for the flywheel. What is the easiest way to remove this so i can fit my own flywheel?
Cheers

Post by **Coops** » Thu Sep 30, 2010 10:04 pm

hacksaw or grinder mate,
had to do the same thing on my 4.6 crank

Teesdale_landrover · Post by **Teesdale_landrover** » Thu Sep 30, 2010 10:38 pm

best thing to do is weld something to it, such as a bolt and use a slide hammer to extract it

ian.stewart · Post by **ian.stewart** » Thu Sep 30, 2010 11:33 pm

another way to get it out is drill and tap it all the way thru then you can jack it out with a bolt

need4speed · Post by **need4speed** » Fri Oct 01, 2010 10:10 am

Thanks for the replies fellas. Think ill run a tap through it and use a bolt to push it out.

sidecar · Post by **sidecar** » Fri Oct 01, 2010 10:29 am

Just hack-sawed mine, it's soft as sh1te!