rear oil seal

v8 pete · Post by **v8 pete** » Fri Jun 11, 2010 12:49 pm

do all engines use the same rear oil seal
or do the 3.9 and 4.6 use the same
i got to take engine out to replace mine .can i replace with out removing the bearing cap.

regards pete

russell_ram · Post by **russell_ram** » Mon Jun 14, 2010 7:21 am

Yes, except for early rope seal P5/6 block the rear oils seals are all identical.

v8 pete · Post by **v8 pete** » Mon Jun 14, 2010 10:44 am

cheers
can i change ok with out removing crank and bearing cap

ChrisJC · Post by **ChrisJC** » Mon Jun 14, 2010 3:34 pm

You can definitely change it without removing the crankshaft.

I don't see why you can't remove it and keep the rear bearing cap in situ.

Be aware that there are cruciform seals in the rear bearing cap which must seal properly, and further, I have had oil leaking down the threads of the two long bolts holding the sump on under that part of the engine!

Chris.

Ian Anderson · Post by **Ian Anderson** » Mon Jun 14, 2010 4:10 pm

Remember it's a Rover
They are either incontinent or trying to mark their territory - I can't figure which

Regards
Ian