Brake line fittings

Rovernuts · Post by **Rovernuts** » Sun Feb 28, 2010 5:19 am

My 3500S NADA has a brake line coming from the brake pressure failure switch to the servo slave cylinder which has 3/8-24 UNF thread on one end and 7/16-20 UNF thread on the other............my question is where do i find a new 7/16-20 UNF thread nut that fits the 3/16 inch brake line.......i have lots of the 7/16-20 nuts that fit 1/4 inch line but that isn't helping me

Thanks
No Brakes

ian.stewart · Post by **ian.stewart** » Sun Feb 28, 2010 7:55 am

Have a look on the Raldes site for fittings
http://www.rallydesign.co.uk/index.php? ... 35q7h8ca47

Ian Anderson · Post by **Ian Anderson** » Sun Feb 28, 2010 8:02 am

Or Think Automotive

http://www.thinkauto.com/acatalog/intro.html

If you cannot see it on line - call them they have most bits and threads available

Ian

stevieturbo · Post by **stevieturbo** » Sun Feb 28, 2010 9:05 am

Surely any decent local motor factors will carry this stuff ??

Rovernuts · Post by **Rovernuts** » Sun Feb 28, 2010 5:52 pm

Thanks for the help.....i think the rallydesign place the fitting is brass which is no good ........but hopefully thinkauto has it in steel.......You'd think they would have them over the pond here but everyone i've spoke to or looked on websites uses an adapter fitting
Cheers
Bill