heading backwards

holley · Post by **holley** » Sun Aug 03, 2008 1:32 pm

Hello Guys I hope you can help me out. I have a pickup truck with a 3.5 v8 which had a flapper efi system on it. I have taken the injection side off and I am in the process of fitting a carb setup from real steel. At the moment all I have done with the wiring is move it to one side and just fitted the manifold and carb to the block. What I need to know is what wiring can I remove and do I need to re-connect anything so the truck will turn over and fire up?

thanks for ya help Holley

Post by **katanaman** » Sun Aug 03, 2008 6:58 pm

The wiring for the flapper system is a separate loom to the rest of the car. You can remove anything from the ECU forward, the only points where it attaches to anything else is power and a signal wire from the coil. Remove these connections and it will all lift out the truck.

holley · Post by **holley** » Sun Aug 03, 2008 7:42 pm

Thank you for the quick reply, when it stops raining I will give it a go.

Cracking website you have here

Post by **katanaman** » Sun Aug 03, 2008 7:45 pm

Glad I could help. If you need anymore help just should, there are a lot of clever guys round here.

Oh and welcome by the way