ARRRGH - Has anyone come up against this?

Boosted LS1 · Post by **Boosted LS1** » Sun Dec 16, 2007 8:55 pm

I assume you know about the rod markings and the correct way to locate the rods because that's not really been mentioned on this thread.

Also if the pistons weren't removed, you'd see the markings pointing the wrong way. Sounds like the yts apprentice did the rebuild if they still have those! With a bit of luck no major damage has been done.

softdash3.9 · Post by **softdash3.9** » Mon Dec 17, 2007 11:57 am

Yes I know the conrod/bearing cap markings, shame the machine shop didn't

"Sounds like the yts apprentice did the rebuild if they still have those"

you might be right

softdash3.9 · Post by **softdash3.9** » Thu Dec 20, 2007 10:03 am

Fingers crossed it should be available to pick up tonight

at Last

softdash3.9 · Post by **softdash3.9** » Thu Dec 20, 2007 10:01 pm

It's Back

and running like it should

ian.stewart · Post by **ian.stewart** » Thu Dec 20, 2007 10:07 pm

Sounds like you got a result, well done

Post by **Coops** » Fri Dec 21, 2007 7:03 am

nice one mate