Crappy running - Coil choice suggestions?

General Chat About Electrics, And Ignition Systems.

Moderator: phpBB2 - Administrators

jwriyadh
Newbie
Newbie
Posts: 45
Joined: Thu Nov 23, 2006 11:27 am
Location: Lincoln

Post by jwriyadh »

The golden rule of running an RV8 has not been mentioned;

ALWAYS USE GENUINE LAND ROVER ROTOR ARM AND DIZZY CAP.


jw


User avatar
The Original Tom
Getting There
Getting There
Posts: 200
Joined: Mon May 14, 2007 1:27 am
Location: Crowborough, UK

Post by The Original Tom »

Now the rotor is genuine, but not the cap. Next time that goes I'll invest £30 and get a propper one.
All I can say now having driven it to work yesterday is "oh my god"!
It can be used as an auto in 3rd gear around town - just dump the clutch in and it pulls away, and will run at under 200 rpm on load with no trouble.
It's freakin' incredible!
No more mis-fires, no more jerking at low RPM, no more chinging gear for long hills, and it runs 10*C cooler too - result all round :D :D :D :D :D :D
Rover 3.5 V8 landy - Completely rebuilt and purring... Now awaiting a good tune!!
Paul B
Forum Contributor
Forum Contributor
Posts: 451
Joined: Sun Nov 19, 2006 7:37 pm

Post by Paul B »

The Original Tom wrote:Now the rotor is genuine, but not the cap. Next time that goes I'll invest £30 and get a propper one.
All I can say now having driven it to work yesterday is "oh my god"!
It can be used as an auto in 3rd gear around town - just dump the clutch in and it pulls away, and will run at under 200 rpm on load with no trouble.
It's freakin' incredible!
No more mis-fires, no more jerking at low RPM, no more chinging gear for long hills, and it runs 10*C cooler too - result all round :D :D :D :D :D :D
I bought a spare dizzy cap from Partco, made from some blue soggy plastic, with about 1mm clearance to the dizzy flange, so it can me wobbled around when in place. Absolute garbage, not much use for anything, apart from as an ashtray, if I smoked.
Post Reply

Return to “Electrical & Ignition Area”