5/16" ball end for pushrods

Post by **Coops** » Sun Sep 13, 2015 11:24 pm

Any one know if you can get a 5/16" ball end for the adjustable end for the adjustable pushrods?

SimpleSimon · Post by **SimpleSimon** » Mon Sep 14, 2015 10:17 am

Tony give Real Steel a tinkle

am sure you have already

sidecar · Post by **sidecar** » Mon Sep 14, 2015 12:15 pm

You can for the non-adjustable end, I'm not sure if you can get two sizes for the adjustable end though!

SimpleSimon · Post by **SimpleSimon** » Tue Sep 15, 2015 9:08 am

sidecar wrote:You can for the non-adjustable end, I'm not sure if you can get two sizes for the adjustable end though!

My bad

I see what Tony is saying, I guess you could always run them upside down with the 5/16 ends facing up and the 3/8 facing the lifters if your using hyd RV8 lifters but it will be a pain having to set the pre-loads with the intake removed

dnb · Post by **dnb** » Tue Sep 15, 2015 11:50 am

Sounds like an excuse for roller rockers to me...

Post by **Coops** » Tue Sep 15, 2015 7:02 pm