Carb flooding issue after stopping engine

General Chat About Exhaust, Cylinder Heads, Fuel Systems And Intake

Moderator: phpBB2 - Administrators

Post Reply
martyn123
Helpful or Confused
Helpful or Confused
Posts: 66
Joined: Sun May 10, 2009 7:39 pm
Location: UK
Contact:

Carb flooding issue after stopping engine

Post by martyn123 »

Image[/img]


martyn123
Helpful or Confused
Helpful or Confused
Posts: 66
Joined: Sun May 10, 2009 7:39 pm
Location: UK
Contact:

Post by martyn123 »

The above photo is of my Edelbrock 1404 carb in my V8 Marcos and have a fuel leakage problem.

After 3-4 years on the road following a full resto i have had my first issue so overall not too bad and take some comfort that the carb was not my installation.

Last week after a brief stop to refuel the Marcos it would not start and put it down to the usual hot start issues or a batch of dodgy fuel, after leaving the car for 30 mins it started again only to cut out again whilst slowing down for a island and again had to leave the car. Drained fuel and put fresh in, looked at plugs and were all black, cleaned them up, (whoever put those chassis rails right next to the heads needs a kick up the backside but leave that for another day)

Just started Marcos again, sweet running, stopped it after two minutes and tried to start again and would not start, head under the bonnet and i could see fuel pouring out from the carb onto the manifold, took the airfilter off to see the carbs full of fuel but was not coming from the two jets but filling up from in the area of the two red arrows on the above photograph. So basically the carb is still filling up after engine stopping and i can hear the knock knock of the fuel pump every few seconds with the ignition switched on hence the engine flooding with fuel and not starting until i have left the car which presumably allows time for the fuel to dry off. Engine is the V8 and Edelbrock 1404 carb, the Marcos was set up on a rolling road 6 month ago and was running great until last week.

Any advice gratefully recieved,

Martyn....
DEVONMAN
Top Dog
Top Dog
Posts: 1440
Joined: Sat Dec 13, 2008 2:46 pm
Location: Croydon UK

Post by DEVONMAN »

I would say the needle in the float chamber is stuck or has some muck in it or your float has punctured.

Regards Denis
1950 A40 Devon Hotrod with 5.0 twin turbo RV8.
EDIS8 wasted spark, Holley Injection.
Been as far as the Moon and back in 57 years of driving. Same Car, 5 engine upgrades !!!


Image
sidecar
Top Dog
Top Dog
Posts: 2399
Joined: Sun Feb 04, 2007 9:52 pm

Post by sidecar »

The two things that you are pointing at are the primary boosters, they are fed fuel by the primary jets and they are the normal place for fuel to enter the air stream. Like what has already been posted it will either by muck in the float valves or a float with a hole in it.
martyn123
Helpful or Confused
Helpful or Confused
Posts: 66
Joined: Sun May 10, 2009 7:39 pm
Location: UK
Contact:

Post by martyn123 »

Thanks for the replies, i shall take the top off and get to the floats to inspect further,


Regards,


Martyn......
martyn123
Helpful or Confused
Helpful or Confused
Posts: 66
Joined: Sun May 10, 2009 7:39 pm
Location: UK
Contact:

Post by martyn123 »

Yes, one float with a hole in it taking on fuel.

Got a new set on order,

Thanks again for advice,


Martyn.....
Post Reply

Return to “Exhaust, Cylinder Heads, Fuel And Intake Area”