4.6 performance spec,

General Chat About Engine Build

Moderator: phpBB2 - Administrators

Post Reply
ian.stewart
Forum Contributor
Forum Contributor
Posts: 2419
Joined: Sat Nov 18, 2006 1:59 pm
Location: Far Far south, any further south and my feet are wet

Post by ian.stewart »

The rod I looked at has a larger Big End, I am sure they wil be available in longer lengths,


THE SMOKING GNU
12.604 with an old boiler of a RV8 and no gas
WHY are there so many IANS on this site???????
Top
el chapo
Newbie
Newbie
Posts: 17
Joined: Mon Dec 15, 2008 5:28 pm

Post by el chapo »

Hi everyone, I wonder if anyone would be to point me in the direction of a good high torque camshaft. The engine will be a 4.6 running on a hotwire EFI probably with a re-chip. This will be going into a series 3 lightweight land rover. Whilst torque is important I don’t want to limit the higher end power too much. Am I correct in thinking that in order to keep low end torque I should leave the heads standard? Does anyone have any experience of the Mark Adams chip? What sort of torque and Bhp would this setup be producing? Sorry for all the questions. Thanks James.
Top
Post Reply

Return to “Engines Area”