Just a quick question, whats the recomended psi rating of the header tank pressure cap?
At the moment the header tanks fitted with a Stant 18-22 psi, will this be OK?
Cheers Steve
Coolant header tank pressure cap rating
Moderator: phpBB2 - Administrators
-
- Helpful or Confused
- Posts: 123
- Joined: Sat Nov 18, 2006 7:58 am
- Ian Anderson
- Forum Contributor
- Posts: 2396
- Joined: Sun Nov 19, 2006 9:46 pm
- Location: Edinburgh
It all depends where in your system your header tank is plumbed into.
For example if it is between your engine and rad you will see a higher pressure requirement than if it is fitted on the suction side return to pump
This could be as much as 5 psi difference
Ian
For example if it is between your engine and rad you will see a higher pressure requirement than if it is fitted on the suction side return to pump
This could be as much as 5 psi difference
Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.