Weber/edelbrock thunder rebuild instructions

Mongman · Post by **Mongman** » Wed May 18, 2011 4:58 pm

The carb i got with the new engine is filthy inside and since it's been sat for a while i wanna give it a clean up and check it over. Anyone got the instructions so i don't ping bits or make a mess of it.

sidecar · Post by **sidecar** » Wed May 18, 2011 5:52 pm

You can download a PDF from the Edelbrock website.

Mongman · Post by **Mongman** » Thu May 19, 2011 4:44 pm

Cheers i'll have a look

Pocket rocket · Post by **Pocket rocket** » Fri May 20, 2011 2:15 am

This might help with the cleaning....http://www.aircooledtech.com/tools-on-t ... a_blaster/

sidecar · Post by **sidecar** » Fri May 20, 2011 6:50 am

Pocket rocket wrote:This might help with the cleaning....http://www.aircooledtech.com/tools-on-t ... a_blaster/

That's bloody clever!

Pocket rocket · Post by **Pocket rocket** » Fri May 20, 2011 8:55 pm

sidecar wrote:
Pocket rocket wrote:This might help with the cleaning....http://www.aircooledtech.com/tools-on-t ... a_blaster/
That's bloody clever!

Obviously not my own idea - nicked from elsewhere

koopsterman · Post by **koopsterman** » Mon Jun 06, 2011 3:55 pm

Likewise !! I will definately be giving that a go.

Devonrod · Post by **Devonrod** » Fri Jul 29, 2011 6:43 pm

I done my weber carbs with soda with a sandblasting gun, got big bags of baking soda from a chinese food warehouse.

My Weber/ edelbrock set up isnt the usual rover type though

=