Bike throttle bodies on rover v8

marko10010 · Post by **marko10010** » Sun Oct 24, 2010 9:54 am

Has anybody sucessfully run bike throttle bodies on a 3500 sd1 type engine? Any advice would be welcome. Thanks

steveshaw · Post by **steveshaw** » Sun Oct 24, 2010 11:49 am

I think Dave Bogg in East Yorkshire has been working with these, worth a look on the website.

marko10010 · Post by **marko10010** » Sun Oct 24, 2010 2:46 pm

Cheers Steve. Do you know his web address?

Will Reeve · Post by **Will Reeve** » Sun Oct 24, 2010 3:12 pm

photo on the manifold page:

http://www.mez.co.uk/ms12.html

Eliot · Post by **Eliot** » Sun Oct 24, 2010 4:40 pm

Will Reeve wrote:photo on the manifold page:

http://www.mez.co.uk/ms12.html

Page one of his build thread suggests it may not be running them anymore - cant be bothered to read the 43 pages to find out..

http://retrorides.proboards.com/index.c ... 945&page=1

Oh ok, randomly started at page 30 and by page 31 it was replaced with a weber and plans for a supercharger - comments about lots of jublie clips holding the bike carbs together also.