Wildcat manifolds

Eliot · Post by **Eliot** » Fri Feb 27, 2009 10:38 pm

Ok treat for you manifold spotters, just had these photo's sent in.

yummy..

http://www.mez.co.uk/ms12.html

john 215 · Post by **john 215** » Sat Feb 28, 2009 12:32 am

Hi,
Very nice

, looks similar to these-

Cheers John

Eliot · Post by **Eliot** » Sat Feb 28, 2009 7:48 am

I'll put those up as well if you dont mind John.

john 215 · Post by **john 215** » Sat Feb 28, 2009 2:53 pm

Hi Eliot,
No problem mate, feel free. Credit where credit is due, the picture shows Mr Steve Greens drag racing MK1 Cortina engine.
Cheers John

CastleMGBV8 · Post by **CastleMGBV8** » Sat Feb 28, 2009 3:48 pm

Unusual dizzy set up on that engine and cant see what feeds the injectors.

Kevin.

john 215 · Post by **john 215** » Sat Feb 28, 2009 4:04 pm

Hi,
I think (but stand to be corrected

) a crank driven pump

Will have to look next time i see this car.
Cheers John

CastleMGBV8 · Post by **CastleMGBV8** » Sat Feb 28, 2009 4:31 pm

John,

I was more curious about how the dizzy is driven, car looks impessive and expensive, do you know what class it runs in and where.

Kevin.

john 215 · Post by **john 215** » Sat Feb 28, 2009 5:01 pm

Hi Kevin,
Steve Green has been drag racing his Cortina MK1 for years, first time i saw it was red and all steel but now fully framed race car in blue,he has run in lots of classes including super pro et running low 8 seconds and i am sure has dipped into the high sevens

The car sounds like no other Rover V8 completely awesome as is the build and engineering on this car. Seen him at a few Peak Performance RWYB days as well. Does enjoy lifting a wheel or two when launching

http://www.youtube.com/watch?v=oi8-Q3mCJ14

Another gent raced a similar spec engine supplied by ICE based on a Wildcat Rover V8 was Tim Garlick in a Cortina MK3 this was even quicker, running mid 7 second runs in Super Mod.

Cheers John

topcatcustom · Post by **topcatcustom** » Sat Feb 28, 2009 6:57 pm

Kevin, I think it is just a right angle drive on the dissy- though admitadly I have not seen them properly before either!

I like the water swirl pot- though some of the problems Rover had were with the top hose pointing downwards weren't they? So with the hot water going in to the top of the pot and out the bottom is it not a similar situation?!

john 215 · Post by **john 215** » Sun Mar 01, 2009 7:56 pm

Hi Eliot,
How about this one, sorry hav'nt got a better picture of the manifold itself

Used to live in the front Tim Garlicks Super Mod Cortina MK3, based on a Wild Cat Rover V8 but breathed heavy on by I.C.E. As you can see running a dual hollies (although poss a split dominator rings a bell

)! and a fair amout of N2O

This was and to the best of my knowledge the fastest Rover V8 over 1/4 of an mile. Was sold on Fleabay in 2007 for a fraction of the cost to build and develop.

Rover V8 Porn

Cheers John