Hi All,
I have just bought a shortened SD1 axle and one of the things I'm looking at is the caps that fit over the axle ends, they cant by fully tightened to sit flush. Pics below
Now I'm thinking that space is the voice that the drum brake back-plate occupies. But I thought I’d check.
Does the plate sit behind or in front of the caps? Anyone shed any light on this?
If the plate goes behind how easy is it to remove the halfshaft to fit a spacer (i'm usine a disc conversion)?
Cheers
Rikko.
Axle end caps
Moderator: phpBB2 - Administrators
Yup - that's the normal way. The half shafts are very easy to remove and replace - they just pull out by handRobrover wrote:The drum brake backplate sits in the gap between the axle shaft and the end of the axle housing.. When I did my rear disc conversion I cut the backplate right down so that the remains of it just acted as a spacer to fill out the gap.
Dave
London SW
Rover SD1 VDP EFI
MegaSquirt2 V3
EDIS8
Tech Edge 2Y
London SW
Rover SD1 VDP EFI
MegaSquirt2 V3
EDIS8
Tech Edge 2Y