Anyone got a milling machine?

chodjinn · Post by **chodjinn** » Tue Jan 12, 2016 10:46 am

I need an inlet manifold milling down, was wondering if there is anyone on here who might be willing to do it? Or know someone who could? Cheers

v8250 · Post by **v8250** » Tue Jan 12, 2016 6:28 pm

I don't, wish I did...but, where are you based? There must be someone near you, a good traditional machine shop. If not, I can recommend some in West Berks and Oxfordshire...

chodjinn · Post by **chodjinn** » Wed Jan 13, 2016 9:43 am

I am in the north west. There is actually a decent old machine shop not far from me but I haven't been for a few years and I think it's now closed unfortunately.