Mk1 Escort
Moderator: phpBB2 - Administrators
-
- Newbie
- Posts: 33
- Joined: Tue Feb 13, 2007 8:45 pm
- Location: kinghorn, fife
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
Cheers fellas and errrm, no, I don't think I'll go for the swap for the Landy Dave
34/36, Bowlers Croft, Cranes Ind Area, Basildon, SS14 3ED
Tel: 01268 527331
You need to speak to the nice chap at FibresportsGalgeth wrote:Nice Nice Nice
Where did you manage to get those zakspeed arches from?
I have been looking everywhere for a set
34/36, Bowlers Croft, Cranes Ind Area, Basildon, SS14 3ED
Tel: 01268 527331
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
1st time back on track
at Donington on 1 July
No vids unfortunately as the car was only out for the 1st two sessions before low oil pressure meant it was parked up but during those sessions I was very pleased with the handling and the engine as far as I pushed it (which wasn't very far)
Also I need to reinforce the leading edge of the bonnet to stop the "Elvis impersonations"
(photos are courtesy of http://www.imagination2image.co.uk )
No vids unfortunately as the car was only out for the 1st two sessions before low oil pressure meant it was parked up but during those sessions I was very pleased with the handling and the engine as far as I pushed it (which wasn't very far)
Also I need to reinforce the leading edge of the bonnet to stop the "Elvis impersonations"
(photos are courtesy of http://www.imagination2image.co.uk )
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
and some more pics and a little vid clip
These were taken at the weekend for the insurance company. It finally got a polish, a mere 10 months after being painted but still hasn't had the interior done but as I've got a new seat to go in to match the Forza it'll get done then
The o/s exhaust is blowing slightly from the collector so it pops and bangs a touch at the moment New full stainless system being made for it as we speak
These were taken at the weekend for the insurance company. It finally got a polish, a mere 10 months after being painted but still hasn't had the interior done but as I've got a new seat to go in to match the Forza it'll get done then
The o/s exhaust is blowing slightly from the collector so it pops and bangs a touch at the moment New full stainless system being made for it as we speak
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
nearly there now
As it was a nice day on Saturday I decided to get the car out of hibernation for the day
This is it warmed up when washing it at the garage. I've just fitted new back boxes with rotational baffles (they're sitting slightly low at the moment but will be raised soon). This is with the boxes on the "quiet" setting.
Bit of a fly past - still only revving it to 4 - 4500rpm as it's not fully run in but it's sounding well
This is it warmed up when washing it at the garage. I've just fitted new back boxes with rotational baffles (they're sitting slightly low at the moment but will be raised soon). This is with the boxes on the "quiet" setting.
Bit of a fly past - still only revving it to 4 - 4500rpm as it's not fully run in but it's sounding well
- NorthernBloke
- Helpful or Confused
- Posts: 61
- Joined: Sun Dec 10, 2006 3:45 pm
- Location: Teesside
- Contact:
A couple of updated photos showing the car finally finished with the graphic kit etc.
Ready for and at this years Lakes Tour - attended by over 160 pre 80 rwd Fords
some other photos here http://s25.photobucket.com/albums/c80/N ... ur%202008/[/QUOTE]
Ready for and at this years Lakes Tour - attended by over 160 pre 80 rwd Fords
some other photos here http://s25.photobucket.com/albums/c80/N ... ur%202008/[/QUOTE]