8 PK SUPERCHARGER PULLEY.

j.johnson23 · Post by **j.johnson23** » Wed Oct 23, 2013 8:50 pm

Does anyone know of,or has a crank damper or pulley that`s around 6 inches in diameter?
Its for a little experiment I am planning involving a v8 and an m112 supercharger.
6+7pk pulleys are easy to come by but 8pk ones seem a bit thin on the ground.
I`m based in the uk(west midlands).
I built a supercharged 1600 cvh ford with a blow thru SU carb a few years ago and it worked really well,now I have a tr7v8 with a low comp engine ive just rebuilt and want to try it again on a bigger scale.

kiwicar · Post by **kiwicar** » Thu Oct 24, 2013 9:54 am

Hi
Is this for measuring up purposes? I have a 6 1/4 Small block chevy sfi damper off my engine at the moment as it is stripped for winter. I could lend it to you for a short while, I would need it back as it is the one for my engine! and I might be driving close by on saturday depending where you are (west midlands is a bit of a wide area.
Best regards
Mike[/b][/u]

j.johnson23 · Post by **j.johnson23** » Thu Oct 24, 2013 5:14 pm

Thanks for reply but I need something permanent.

mgbv8 · Post by **mgbv8** » Thu Oct 24, 2013 8:44 pm

By 8pk do you mean an 8 groove pulley?

What engine is this for?

Post by **Coops** » Thu Oct 24, 2013 9:06 pm

im only running 7pk on my supercharged v8

kev_the_mole · Post by **kev_the_mole** » Fri Oct 25, 2013 9:03 am

I can make you an 8PK pulley but setup times really jack up the prices on a one-off.

j.johnson23 · Post by **j.johnson23** » Fri Oct 25, 2013 6:16 pm

Thanks for replies but i think it may be sorted now.