boost gauge fitment on twin turbo.
Moderator: phpBB2 - Administrators
boost gauge fitment on twin turbo.
On a twin setup is a tube from each inlet pipe joined together then to the gauge ok or will this give dodgy reading? Or is a seperate gauge for them both needed? Sounds like a daft question but I'm just wondering if say 1 side was pushing out 7 psi and the other was 4 psi I wouldn't know,I would just presume that 12 psi shown was the average?? Hmmm can't get my tiny mind round it ha ha
-
- Forum Contributor
- Posts: 3979
- Joined: Sat Nov 18, 2006 6:22 pm
- Location: Northern Ireland
There is a connection on each of the boost crossover pipes that you can use for a boost gauge. You can either T them together for one gauge, or use two separate lines to run two gauges, which is how I had it mate. Cheers
RIP MGB V8 .... served me well as a learning curve.
R32 Skyline V8 .... this one is gonna be a monster!
R32 Skyline V8 .... this one is gonna be a monster!