Help> RV8 Main Bearing Cap Rear Cruciform Seal !!

Slatter · Post by **Slatter** » Fri Dec 08, 2006 8:00 am

Hi people ive taken my engine apart for a mild rebuild ( well someone helped) !! Now in the rear cap we took out the seal and it is in the shape of a + almost or more a cross, with my rebuild kit from mr eales i got a rubber seal BUT its straight with 2 5mm stubbs coming out either side.... would these be new style seals that i am needing???

Any help or advice would be appreciated

Thanks Slatter

jrv8 · Post by **jrv8** » Fri Dec 08, 2006 9:40 am

Hi ,
These are the latest type of rear cruxiform seal from Landrover, and a lot easier to fit than the earlier ones.
They're fine.
Jim

Slatter · Post by **Slatter** » Fri Dec 08, 2006 7:58 pm

Here is a picture of the rubber things that i was sent ..... are these what i am looking for??? There are 2 channels on the bearing cap so which 1 would i put it into ???

Thanks Slatter

jrv8 · Post by **jrv8** » Fri Dec 08, 2006 8:04 pm

Hi,
That's the ones, and they will only fit sensibly the one way.
They've just got a shorter crossbar than the earlier type.

Jim

Slatter · Post by **Slatter** » Fri Dec 08, 2006 8:16 pm

Thanks very much for the help jim

softdash3.9 · Post by **softdash3.9** » Fri Dec 08, 2006 9:08 pm

Also need a smear of blue hylomar to complete the rear brg cam seal to complete assy

I received these seals when I rebuilt my 3.9V8 and they are easier to install that the X type seals

used both earlier typewas a little more taxing

Boosted LS1 · Post by **Boosted LS1** » Mon Dec 11, 2006 4:47 pm

Put sealant around the side and underside of the cap where it mates to the block. This will stop oil leaking out. I think you should also trim off the portion of the cruciform seal which remains proud but still leave a couple of millimeteres projecting?

Boosted.