Has anyone got any pictures of a v8 rover block fitted with knock sensors as I would like to fit them to my early engine and want to get them in the correct place.
Thanks
Found one picture on RPI site that shows location on dipstick side, just need drivers side now.
Knock Sensors
Moderator: phpBB2 - Administrators
Check out my rebuild page (shed loads of images)
http://www.cowdery.org.uk/v8rebuild.php
There's a knock sensor in the non dipstick side, and you can see the mounting for the sensor in the other side in the same place.
Chris.
http://www.cowdery.org.uk/v8rebuild.php
There's a knock sensor in the non dipstick side, and you can see the mounting for the sensor in the other side in the same place.
Chris.
--
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
- Pocket rocket
- Getting There
- Posts: 256
- Joined: Sun Nov 19, 2006 1:08 am
- Location: Hawkinge, Kent
The holes are blind.
A knock sensor is a type of microphone, which is hooked up to the ECU which listens for the characteristic sound of pre-ignition. That way the ECU can run the timing much closer to optimum as it has a safety mechanism to detect pinking. A distributor can't do that of course.
Chris.
A knock sensor is a type of microphone, which is hooked up to the ECU which listens for the characteristic sound of pre-ignition. That way the ECU can run the timing much closer to optimum as it has a safety mechanism to detect pinking. A distributor can't do that of course.
Chris.
--
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8