Fuel pump relay
Moderator: phpBB2 - Administrators
-
- Forum Contributor
- Posts: 3979
- Joined: Sat Nov 18, 2006 6:22 pm
- Location: Northern Ireland
And again it depends what relay you were using in the first place.berty wrote:Basically the mountain bracket off the relay as broken off and I got a few 30a relay around so just wondering if I could use one off themDaveEFI wrote:Yes, in principle. But more information needed.
But do be aware, with automotive relays there are 2 typical pin configurations, so ensure you're swapping like for like in terms of pin numbers.
For some reason they are different...and will not like being fitted incorrectly, but the physical pins are in the same place ! But the connections are different internally.
-
- Newbie
- Posts: 17
- Joined: Fri Oct 10, 2014 7:15 pm
If you are talking Lucas injection where the two relays (main and pump) are twin output types, yes. Only the main relay needs to be a twin output one. The more common single pole changeover 5 pin is fine for the pump, as there is no connection to 87, the normally closed contact.
Dave
London SW
Rover SD1 VDP EFI
MegaSquirt2 V3
EDIS8
Tech Edge 2Y
London SW
Rover SD1 VDP EFI
MegaSquirt2 V3
EDIS8
Tech Edge 2Y