SD1 Vitesse Flapper conversion to hot wire

swight · Post by **swight** » Sun Apr 22, 2007 6:01 pm

How easy is it to fit a 3.9 Hot wire engine into a SD1 Vitesse with the flapper system. What do I need to do to change the wiring system, i.e. do I need the loom from the Range Rover with the ecu. Thanks, Steve

badger · Post by **badger** » Sun Apr 22, 2007 6:42 pm

Change complete system over - inlet manifold, pipework, airmeter, harness etc and fit a landrover discovery 3.5efi hotwire ecu as the 3.9 ecu will overfuel.

Post by **Coops** » Sun Apr 22, 2007 7:23 pm

3.5 hotwire?
when did that come out?????
and why will the 3.9 ecu over fuel???
i ran a complete 3.9 system and ecu on a 3.5 and it never overfuelled one bit.

swight · Post by **swight** » Sun Apr 22, 2007 8:11 pm

Thanks for the replies. What I want to do is fit a complete 3.9 engine and components to my SD1, so what I need to know is how do I mate the hot wire loom to my sd1. Thanks, Steve

Post by **Coops** » Sun Apr 22, 2007 9:12 pm

what i did was find the 5 pin plug on the sd1 efi loom, cut the plug off the flapper efi side, and wired the hot wire loo to the plug and connected it back to the car plug.
there are two wiring diagrams on th forum so you can cross reference what colour does what on the 3.5 and 3.9 looms,

landybob_v8 · Post by **landybob_v8** » Tue Apr 24, 2007 5:47 pm

the late discoverys before the change to 3.9 had 3.5 on hotwire tony

Post by **Coops** » Tue Apr 24, 2007 6:12 pm

well i never knew that,
something else i have learnt.