My engine doesn't have a dirt shield covering the flywheel and I think it should have one but not sure on which one I need?
It's a 86 engine with a BW auto bell housing (ford gearbox) ,I can see 4 potential mounting holes on the bell housing, two on the flat side at the bottom and two higher up, one lower down than the other.
Two holes in the block facing down.
Any suggestions
Thanks
Steve
Dirt shield
Moderator: phpBB2 - Administrators
Re: Dirt shield
You need one from a Rover P5B or P6B auto.
Re: Dirt shield
Might be easier/quicker to just make one out of some flat ali sheet?
Dax Rush 4.6 supercharged V8 MSII
Re: Dirt shield
Found a NOS shield for a P6 manual and it's a perfect fit.
Re: Dirt shield
Easy sorted