LT77 question.. althogh its proberbly obvious...

General Chat About Drivetrain & Transmission.

Moderator: phpBB2 - Administrators

Post Reply
JC.
Getting There
Getting There
Posts: 249
Joined: Mon Nov 20, 2006 5:16 am
Location: Alfreton, Derbyshire
Contact:
Contact JC.

LT77 question.. althogh its proberbly obvious...

Post by JC. »

The gearlever on an LT77 2wd box....

Do you have to lever the springy things over the top of the pegs either side of the gear lever and then screw the bolt down?
or do the pegs sit on top?


Image -JC.
Top
ian.stewart
Forum Contributor
Forum Contributor
Posts: 2419
Joined: Sat Nov 18, 2006 1:59 pm
Location: Far Far south, any further south and my feet are wet

Post by ian.stewart »

yep, they provide 3rd-4th lever bias, and sit on the pins either side of the ball on the gearlever. and on top of the adjusting bolts
THE SMOKING GNU
12.604 with an old boiler of a RV8 and no gas
WHY are there so many IANS on this site???????
Top
User avatar
davemgb
Helpful or Confused
Helpful or Confused
Posts: 143
Joined: Sat Nov 18, 2006 5:55 pm
Location: Just north of watford

Post by davemgb »

There are several versions of the gearshift remote setup and I hope you have a short version - any one levering the spring on the long variant will probably never get the shift to settle in the 3/4 gate properly again.

Dave
Top
JC.
Getting There
Getting There
Posts: 249
Joined: Mon Nov 20, 2006 5:16 am
Location: Alfreton, Derbyshire
Contact:
Contact JC.

Post by JC. »

its the remote straight out of an SD1 if thats any use?
Image -JC.
Top
Post Reply

Return to “Drivetrain & Transmission Area”