The four setscrews (M8) holding the remote gear housing to the extension case I believe torque all upto 25nm/18ft/lbs?
The front two I can believe as the inner metal sleeve in the rubber buffers only allows slight compression but the inner metal sleeves on the sides are much smaller than the rubber buffers.
I have three rubber washers for all the set screws. Have I installed one too many on the sides?
R380 - remote gear lever housing
Moderator: phpBB2 - Administrators
-
- Forum Contributor
- Posts: 594
- Joined: Sat Nov 18, 2006 6:10 pm
- Location: Bicester, Oxfordshire
- Contact:
-
- Forum Contributor
- Posts: 594
- Joined: Sat Nov 18, 2006 6:10 pm
- Location: Bicester, Oxfordshire
- Contact: