Hi guys hope somebody can shed some light on my problem i have fitted a brake master cylinder and servo off a '89 onward ford fiesta the type with a cast body to my '34 ford hot rod. it has 4 outlets 2 close to the servo and 2 away from the servo each of these 2 outlets have different size unions.My question is which corner of the car do each of these outlets feed is it split diagonally or front/rear?
Many thanks Martin
Fiesta master cylinder
Moderator: phpBB2 - Administrators
-
- Newbie
- Posts: 2
- Joined: Sun May 23, 2010 9:25 am
- Location: Stockport
-
- Forum Contributor
- Posts: 3979
- Joined: Sat Nov 18, 2006 6:22 pm
- Location: Northern Ireland
-
- Newbie
- Posts: 2
- Joined: Sun May 23, 2010 9:25 am
- Location: Stockport
fiesta master cylinder
Hi guys
Thanks for the replies the master cylinder has a red plastic tag around the body with some numbers 36UX 66355 05 50/50 not sure which number is start cos it goes round in a circle
Many thanks Martin
Thanks for the replies the master cylinder has a red plastic tag around the body with some numbers 36UX 66355 05 50/50 not sure which number is start cos it goes round in a circle
Many thanks Martin
Couldn't recognise the numbers you gave me. I have checked a couple of master cyl's for the fiesta Mk III and they all had straight dia cyl bores (i.e. not stepped) so i'd assume yours will be to , which means you should be able to split it how you want.
I'd spilt it front/rear. If you have two different sized fittings i'd keep these to the same end of the car. (e.g. 2x M10x1 to the rear and 2x M12x1 to the front.)
Tom.
I'd spilt it front/rear. If you have two different sized fittings i'd keep these to the same end of the car. (e.g. 2x M10x1 to the rear and 2x M12x1 to the front.)
Tom.
Dax Rush 4.6 supercharged V8 MSII