Rover V8 Cylinder Head Numbers
Moderator: phpBB2 - Administrators
Re: Rover V8 Cylinder Head Numbers
Hi Im wondering can you use the neoprene stem seals instead of the tap (washer) type seal?
- Attachments
-
- ERR1782P.JPG (11.66 KiB) Viewed 4539 times
Re: Rover V8 Cylinder Head Numbers
Yes you can.
The question is whether the valve guides are different - I believe they are but am not 100% sure.
Chris.
The question is whether the valve guides are different - I believe they are but am not 100% sure.
Chris.
--
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
Re: Rover V8 Cylinder Head Numbers
Note that ALL the heads will fit ALL the blocks, only difference being the 4 outer bolt holes on late heads are not drilled- HRC2479.
Later valve guides have steps on the top to take the stem seal shown above. There is talk in the engine manual for 3.9 and 4.2 of a new exhaust valve called 'carbon break', which use a 2mm shorter guide, but I cant find any official mention of these valves anywhere.
Later valve guides have steps on the top to take the stem seal shown above. There is talk in the engine manual for 3.9 and 4.2 of a new exhaust valve called 'carbon break', which use a 2mm shorter guide, but I cant find any official mention of these valves anywhere.