measurement please

bodger · Post by **bodger** » Fri Nov 30, 2007 3:55 pm

can anyone tell me how long the SD1 LT77 bell housing is please :

IE: from engine to box ?

thankyou ..

davemgb · Post by **davemgb** » Fri Nov 30, 2007 10:07 pm

RPi website says 18.5mm which I suspect should have been typed as 185mm.

This seems a little short to me but I don't have a bell housing to hand at the moment. I'll check in the cold harsh light of day...

Oh, this is presumably for a sportscar/SD1 since I know the four wheel drive housings are somewhat longer.

Dave

EDIT:-
Saturday afternoon now and I have measured up - 180mm.

ian.stewart · Post by **ian.stewart** » Sat Dec 01, 2007 1:52 pm

from memort , around 171mm

tetlow · Post by **tetlow** » Sat Dec 01, 2007 2:38 pm

180mm

bodger · Post by **bodger** » Sat Dec 01, 2007 11:01 pm

thanks guys ...i was hoping to use my existing bell housing ( a series one with adaptor ring ) but it's nearer 220mm
i have an old 2.0 ltr sherpa box on there and i was going to replacit with an lt77

bodger · Post by **bodger** » Tue Dec 04, 2007 10:48 am

Hello again , plan B ...now

can anyone tell me the total length from front of bell housing to output flange please ?

chrismc · Post by **chrismc** » Tue Dec 04, 2007 6:23 pm

From the front of the bellhousing to the output flange- 670mm.(approx)

bodger · Post by **bodger** » Sat Dec 08, 2007 1:48 am

thankyou Chris

bodger · Post by **bodger** » Tue Feb 05, 2008 11:45 am

more measurements please ...

LT77 , front end

= from front face to the end of the input shaft
= from front face to end of splines
= from front face to end of thrust tube
= diameter of the splines ..24.9 or 25.4 ? it is 23 splines
and the length of the spigot tip
please gents