I’m looking for a particular part and wondered if anyone knows where to find it..
Had a problem with the clutch release so took engine and gearbox out of car, cracked open bellhousing and found that my clutch release arm was hanging off the release bearing.
The reason was that on the end of the arm (the end with the 2 circular prongs) I only have one square nut to guide the arm onto the release bearing with. Looks like I have a missing square nut.
I have looked at getting a new arm but nobody seems to know anything about the square nuts.
The picture shows the arm and at the top of the picture is the 1 square nut I do have.
Anyone??
Thanks in advance
Clutch release mechanism
Moderator: phpBB2 - Administrators
-
- Forum Contributor
- Posts: 2419
- Joined: Sat Nov 18, 2006 1:59 pm
- Location: Far Far south, any further south and my feet are wet
Rimmer bros have them listed,
they call it a slipper pad, http://www.rimmerbros.co.uk/rimmer/rover/sd1/clutch
Ian
they call it a slipper pad, http://www.rimmerbros.co.uk/rimmer/rover/sd1/clutch
Ian
THE SMOKING GNU
12.604 with an old boiler of a RV8 and no gas
WHY are there so many IANS on this site???????
12.604 with an old boiler of a RV8 and no gas
WHY are there so many IANS on this site???????
-
- Forum Contributor
- Posts: 2419
- Joined: Sat Nov 18, 2006 1:59 pm
- Location: Far Far south, any further south and my feet are wet