Hopefully this is a simple question, currently building a kit car with an RV8 (standard spec except for mild cam), LT77 gear box and Granada diff. Prop shaft will need to be shortened and an amalgamation of the SD1 and Ford to ensure correct flanges. However the track of the car is different to the original Ford Granada that the diff and driveshafts are from.
The question is can the driveshafts be extended by cutting and sleaving to fit the correct track dimensions. If so what would be an estimated cost for this. Any good recommendations in the Cambridgeshire area?
Driveshaft extension
Moderator: phpBB2 - Administrators
Try Bailey Morris http://baileymorris.co.uk/ in St. Neots. They do propshafts, not sure about driveshafts.
Chris.
Chris.
--
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
Series IIA 4.6 V8
R/R P38 4.6 V8
R/R L405 4.4 SDV8
- Ian Anderson
- Forum Contributor
- Posts: 2396
- Joined: Sun Nov 19, 2006 9:46 pm
- Location: Edinburgh
Try the breakers yard for a VW Transporter Mk2
The CV-s are same bolt spacing and from memory the driveshaft is longer
Ian
The CV-s are same bolt spacing and from memory the driveshaft is longer
Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.