The V8 Owners Forum -

Pipework adjusted at the weekend, went out yesterday in sunshine but only 4C..Wet roads no traction! Heater feed pipe now connected directly to bottom hose near pump inlet. throttle body pipes blocked off. Temp seemed perfect holding about 79-80d on my temp sensor which is about 10d wrong! re-sealed...

Guys, Thanks for comments, plan as follows:-

Disconnect throttle body pipe from manifold and cap off one side/use for bleeding any air etc. Connect Heater 16mm pipe to pipework near inlet pump and add a flow restrictor if required to make sure most water heads through thermostat when open.

Have attached a picture below to show my current setup. On the left of the photo is the heater connection capped off, after the thermostat I have a pipe direct to the radiator, no bypass from this location, Then just close to the water temp sensor is a pipe currently connected to the Throttle body o...

Hi all, I am newbie to forum and have just registered a V8 Dax Rush back in November :) Quick and hopefully fairly straight forward question for my first post, I currently have my heater feed pipe from the inlet manifold capped off but have an 8mm pipe from the manifold(opposite side) feeding the th...