Page 1 of 1
Squirt + Jolty Options
Posted: Mon Apr 04, 2011 7:41 pm
by Rossco
Ok, so I now have an MS1 Extra and all the gubbins to get it fitted and running.
What are my options with this, i.e. is it bank fire only or can it run full sequential....what can this baby do?
Posted: Mon Apr 04, 2011 8:45 pm
by spend
It should be able to run sequential, just need to chop off 6 cylinders to make it work
Posted: Tue Apr 05, 2011 5:49 am
by Rossco
spend wrote:It should be able to run sequential, just need to chop off 6 cylinders to make it work
Right......a 9" angle grinder should do that
Re: Squirt + Jolty Options
Posted: Tue Apr 05, 2011 8:30 am
by DaveEFI
Rossco wrote:Ok, so I now have an MS1 Extra and all the gubbins to get it fitted and running.
What are my options with this, i.e. is it bank fire only or can it run full sequential....what can this baby do?
You need MSIII and an expansion board for this.
It depends on who you talk to - but most reckon sequential has more to do with emission control than the actual running, although it may give a small improvement at very low engine speeds. But for that, you'd likely need so way of finding out which each individual cylinder is doing.
Posted: Tue Apr 05, 2011 12:56 pm
by kiwicar
Hi
I would go with what you have and go for batch/bank fire, you will have more than enough to fiddle with wtih that. Sequential would need ages on a dyno to set up any better than batch fire anyway. You can set it up to fire inner two on each bank with the outer two from the other bank, and to fire each batch/bank every 360 degrees of crank rotation, that way they have a much simpler relationship of injection point the point in the over all engine cycle.
Best regards
Mike