Page 1 of 1
4.6 Crank
Posted: Thu Sep 30, 2010 10:00 pm
by need4speed
Offered up my 3.9 flywheel to my engine to discover that the 4.6 crank has a locating dowel in it for the flywheel. What is the easiest way to remove this so i can fit my own flywheel?
Cheers
Posted: Thu Sep 30, 2010 10:04 pm
by Coops
hacksaw or grinder mate,
had to do the same thing on my 4.6 crank
Posted: Thu Sep 30, 2010 10:38 pm
by Teesdale_landrover
best thing to do is weld something to it, such as a bolt and use a slide hammer to extract it
Posted: Thu Sep 30, 2010 11:33 pm
by ian.stewart
another way to get it out is drill and tap it all the way thru then you can jack it out with a bolt
Posted: Fri Oct 01, 2010 10:10 am
by need4speed
Thanks for the replies fellas. Think ill run a tap through it and use a bolt to push it out.
Posted: Fri Oct 01, 2010 10:29 am
by sidecar
Just hack-sawed mine, it's soft as sh1te!
