Page 1 of 1
Which Starter for clearance..?
Posted: Fri Apr 09, 2010 6:59 pm
by burble
Problems with clearance putting Rover 3.5 into Tvr.
Had a look and find that the SD1 has the solenoid underneath whereas mine has the solenoid on the side of the starter which is fouling my chassis.
Is there an alternative starter with the solenoid on top of the starter please.
Posted: Fri Apr 09, 2010 8:53 pm
by kiwicar
I think this may be worth a read
http://www.v8forum.co.uk/forum/viewtopic.php?t=7095
Best regards
Mike
Posted: Fri Apr 09, 2010 8:59 pm
by burble
Ta Mike,
Did have a read through that but missed the bit where it said use 9m 90 Lucas.
I presume that is the one I want with the solenoid on top, I'll have a look round for one next week.
Still trawling for gearbox, look like it's going to be a long job
Pete
Posted: Fri Apr 09, 2010 10:11 pm
by gelmonkey
Pete
If you have a problem finding a 9m 90 then send me a pm and I will see what I can find down here for you.
Have a local guy who seems to have an endless supply of them.
Cheers
Paul
Posted: Fri Apr 09, 2010 10:20 pm
by burble
gelmonkey wrote:Pete
If you have a problem finding a 9m 90 then send me a pm and I will see what I can find down here for you.
Have a local guy who seems to have an endless supply of them.
Cheers
Paul
Thaks for that, I'll have a look what starter is on my V8 Land Rover, it may be different to the one on the engine I'm testing in the TVR.
If not then I'll definately give you a call.
Pete