Page 1 of 1
Brake line fittings
Posted: Sun Feb 28, 2010 5:19 am
by Rovernuts
My 3500S NADA has a brake line coming from the brake pressure failure switch to the servo slave cylinder which has 3/8-24 UNF thread on one end and 7/16-20 UNF thread on the other............my question is where do i find a new 7/16-20 UNF thread nut that fits the 3/16 inch brake line.......i have lots of the 7/16-20 nuts that fit 1/4 inch line but that isn't helping me
Thanks
No Brakes
Posted: Sun Feb 28, 2010 7:55 am
by ian.stewart
Posted: Sun Feb 28, 2010 8:02 am
by Ian Anderson
Or Think Automotive
http://www.thinkauto.com/acatalog/intro.html
If you cannot see it on line - call them they have most bits and threads available
Ian
Posted: Sun Feb 28, 2010 9:05 am
by stevieturbo
Surely any decent local motor factors will carry this stuff ??
Thanks for the help
Posted: Sun Feb 28, 2010 5:52 pm
by Rovernuts
Thanks for the help.....i think the rallydesign place the fitting is brass which is no good ........but hopefully thinkauto has it in steel.......You'd think they would have them over the pond here but everyone i've spoke to or looked on websites uses an adapter fitting
Cheers
Bill