Page 1 of 1

anyone know 3.9 rv8 weight????

Posted: Tue Feb 13, 2007 9:12 pm
by nickh
hi everyone im new to this forum and hoping some of you peeps can help need to know the weight of a range rover 3.9 v8???

cheers in advance nick :D

Posted: Tue Feb 13, 2007 9:17 pm
by softdash3.9
Complete V8 @ 230kgs, source RPI website :wink:

Posted: Tue Feb 13, 2007 10:52 pm
by nickh
nice one cheers mate :D :D

Posted: Wed Feb 14, 2007 7:58 am
by ChrisJC
You sure that's not lbs rather than kgs? 1/4 ton seems rather a lot!

Chris.

Posted: Wed Feb 14, 2007 10:06 am
by smokeonthewater
Yeah I think 230kg sounds abit heavy :!:
I would say it was just a good 2 man lift as me and my brother lifted one into/out of a landrover, then carried it down my garden to the shead by the header pipes :wink:

230lbs I think is about 104kg which sounds more like it to me

P.s It was heavy though :lol:

Posted: Wed Feb 14, 2007 10:21 am
by jrv8
Hi,

I've a book of V8 engine data & weights, and it's showing the Buick 215 (RV8) engine as weighing in at 318 lbs .

This doesn't seem too far away , as already stated, it's a heavy two man lift.

Jim

Posted: Wed Feb 14, 2007 10:45 am
by smokeonthewater
I looked on the wikipedia site & they say its about 170kg, and the V8church website say about 320lb which is about 145kg :? :? :? :? But they also put a little note about the weight being- "Approx, will vary depending upon nature of ancillaries fitted. "


:)

Posted: Wed Feb 14, 2007 11:21 am
by softdash3.9
See below:-

http://www.rpiv8.com/engine-4.htm

Haven't weighed one myself, all up weight inc ancillaries

Posted: Wed Feb 14, 2007 11:42 am
by katanaman
Could be that weight with every conceivable ancillary on the engine which you wouldn't be running anyway. Even then I think RPI have it wrong. I would say in normal trim its around the 145-150KG. A 302 is 210-220KG with starter carb and alternator. There will always be variations in engine weight depending what you have bolted onto the engine.

Posted: Wed Feb 14, 2007 2:57 pm
by adamnreeves
The short block I now weighs 80Kgs. I took the PRI 230Kgs figure to include everything and I mean everything, transmission and all.

Posted: Tue Mar 13, 2007 11:45 am
by jsstevo1
Found the below :-

Width = 26'
Length = 28'
Height = 27'
Weight = 320 lbs
Note: Approx, will vary depending upon nature of ancillaries fitted.

Cheers!

Posted: Sun May 27, 2007 7:01 pm
by Paul Dryhurst
Ring this No: 01926 646974 ask for John (Weights Department Land Rover). He will tell you what you want to know if you give him the spec. Man ,Auto, Air con, with oil , pas etc.
Regards
Paul (mention my name.