Page 1 of 1
Alternator wiring problem
Posted: Mon Jul 13, 2009 6:39 pm
by V8 RX-7
Having trouble wiring my lucas alternator to charge through a rally cut off switch. it has three terminals 2 threaded, one towards the centre and one at the edge, and 1 spade connector can anyone tell me which is the charging post and what are the other 2 for, it is not running any electrics besides bare essentials to run engine, no lights etc.
Posted: Mon Jul 13, 2009 8:40 pm
by ChrisJC
Gotta pic?
Chris.
Posted: Tue Jul 14, 2009 6:58 am
by V8 RX-7
hopefully should show
[/img]
Posted: Tue Jul 14, 2009 7:28 am
by ChrisJC
Is there any lettering near the connections - I can't make any out?
Chris.
Posted: Tue Jul 14, 2009 7:34 am
by V8 RX-7
hi chris the only lettering i can make out is a 0 or zero between the top connector with the nut on and the spade connectot, there is a dash or - next to the lower threaded connector but not sure if it is just a floor in plastic or not cheers
Posted: Tue Jul 14, 2009 10:36 am
by ChrisJC
Ah, well in that case I'm not sure!
I would go for the larger one being the BAT+
Hopefully somebody else will recognise the pic for the Charge light.
Chris.
Posted: Fri Jul 17, 2009 10:01 pm
by bodger
if you know what it's off have a look here :
http://www2.qha.com/q-pid/QPID.aspx?user_id=&session=
tells you the termial config in the specs