Page 1 of 1
Range Rover in-tank pump dimensions
Posted: Tue May 12, 2009 9:47 pm
by kev_the_mole
Anybody know the depth from flange to pump base of this RR P38 4.0/4.6 94-98 injection pump?
want to fit it in here to eliminate the need for a swirl and external pump
Posted: Tue May 12, 2009 10:35 pm
by JSF55
I think i used this one on my efi conversion
http://cgi.ebay.co.uk/RANGE-ROVER-CLASS ... 7C294%3A50
Managed to trim it down to about 7" tall to fit in my tank, worked a treat
Posted: Tue May 12, 2009 10:48 pm
by kev_the_mole
Do you know how deep it was before you modified?
Cheers,
Ian
Posted: Wed May 13, 2009 8:04 am
by JSF55
I don't think i shortened by more than about 2 inches, 2 1/2 inches tops, i have a better photo of that pump here, next to a pen to reference the size, pm me if you want a copy of it sent, john
Posted: Wed May 13, 2009 10:11 am
by kev_the_mole
John,
PM sent.
Cheers,
Ian
Re: Range Rover in-tank pump dimensions
Posted: Sun May 17, 2009 1:00 pm
by mjheathcote
I like the look of this for my Stag EFI project, but how do you mount it to the top of the tank?
The earlier RR one is easier to mount, but does not have an inbuilt swirl pot arrangement.
Cheers,
Mike.
kev_the_mole wrote:Anybody know the depth from flange to pump base of this RR P38 4.0/4.6 94-98 injection pump?
want to fit it in here to eliminate the need for a swirl and external pump
Posted: Mon May 18, 2009 1:08 pm
by kev_the_mole
Mike,
from what I've seen you cut the hole in the tank to fit the sender and the gaskets and then fabricate some sort of circular or hold down clamps.
Ive got a sump in my tank so I'll place the pump in that and just modify the length. That should get rid of the need for a swirl pot.
Cheers,
Ian