Page 1 of 1
Hotwire Fuel rail to Adjustable FRP
Posted: Mon Jul 07, 2008 11:35 am
by TVRleigh
Anyone know if there is an adaptor for the hot wire fuel rail so you can fit an after market Fuel pressure regulator.
Thanks
Leigh
Posted: Mon Jul 07, 2008 3:17 pm
by Eliot
RPI sell a kit:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 3a2QQfviZ1
(this is a nasty non 1:1 FPR btw..)
But I would try calling:
http://www.fuelsystem.co.uk/
As they are "FSE".
Posted: Mon Jul 07, 2008 7:13 pm
by JSF55
WOW
i just cut the rail about an inch from the injectors and had to "barbs" tigged in, cut them down from some fittings from Pirtek and ground them to suit the bore of the pipe
Posted: Tue Jul 08, 2008 9:19 am
by TVRleigh
Thank you.
Strange as I asked RPI and they did not know what I was on about.
Posted: Tue Jul 08, 2008 9:10 pm
by Coops
if you get the correct fuel reg you get an adaptor,
my rising rate reg came with a brass adaptor that had an o ring on, this went into the fuel rail where the o/e fuel reg went, and was held in place using the bolt holes on the fuel rail where the o/e one bolted to,
the other end of the brass fitting has a pipe tail,
in the box is two lengths of pipe too, one from brass adaptor to new fuel reg, other pipe from fuel reg to return pipe,