Page 1 of 3
jacobs controller
Posted: Sun Jun 01, 2008 10:25 pm
by bones
think this is the right place for this , ive got a jacobs progressive controller, and im using a mallory unilite and c4 coil, the wiring diagram for the controller shows a yellow wire going to a green from the coil , and red to the red wire from the coil and ballast resistor, the c4 coil doesnt have any wires coming from it, and the unilite diagrams dont show the use of a controller, any ideas as ive lost the 2nd sheet of the wiring
rich
Posted: Mon Jun 02, 2008 7:23 am
by russell_ram
Not sure from your post what you actually want, but I have the wiring diag for a Jacobs controller if that's hwat you need. I can scan and mail later if thats what you need.
Russ
Posted: Mon Jun 02, 2008 12:30 pm
by bones
hi, i dont think i got it over to good on the post, the wiring diagram would be great if you could put that up for me, ive lost the part about the red and yellow and red and white wires and where they go, as the nos system does not work, and i want to check the wiring, thanks again
rich
Posted: Mon Jun 09, 2008 5:29 pm
by bones
well i couldnt the controller to work, i checked the jets and i assume they are a 50 shot, 43 and a 32 , if i remember right,
Posted: Fri Jun 27, 2008 10:54 pm
by mgbv8
Any luck yet Rich??
Posted: Sat Jun 28, 2008 12:41 pm
by bones
hi Perry, not at the moment, i wired the nos up to go off the button and forgot the controller, but i still need the diagram for it, so as to check the wiring of it, how you doing, and i need a number 47 jet as real steel had run out of them, and i need it for the 75 and 100 shot,
Posted: Thu Jul 03, 2008 8:54 am
by bones
has anyone got the wiring diagrams for the jacobs nos controller to the hyfire box and unilite dizzy please that they could post up or e-mail to me, thanks for any help
rich
Posted: Sun Jul 20, 2008 6:38 pm
by bones
ok i got some diagrams now for the controller,
rich
Posted: Tue Sep 23, 2008 7:25 pm
by bones
happy days, we got the controller wired up , going to test it at the weekend, october at the pod looks good
rich
Posted: Tue Sep 23, 2008 7:53 pm
by ian.stewart
Taking it to Battlesbridge this weekend then????
Posted: Wed Sep 24, 2008 7:24 am
by bones
No, just a quick test on a bit of road to see if the controller is doing what it should do, and ive never been to battlebridge ,whats it like ?
rich
Posted: Wed Sep 24, 2008 8:25 am
by ian.stewart
theres a Ford show down there on Sunday, If I can get my car back together I will be there. The last one I went to was packed out, its only about 20mins from you, over the little bridge and behind the antiques mill? probably a good move to get there reasonably early as the little road gets busy.
Posted: Thu Sep 25, 2008 6:15 am
by bones
i might see you there then,
rich
Posted: Sun Sep 28, 2008 10:32 pm
by bones
didnt make it to battlebridge, but i did test the controller and it works fine, got jets for a 125 shot in october,
rich
Posted: Mon May 11, 2009 4:46 pm
by bones
Ok time to drag this old post back up, the jacobs controller doesnt seem to be working the solenoids, the solenoids are if i by pass the controller, Is there away of testing the jacobs is letting power to the solenoids, I will be going through the wiring again to see if i have a bad connection somewhere, The trigger switch and arming switch are fine and so are the solenoids, so it looks like the controller is messing about,
